1

Your cart is empty.

Product Image Seal Over Plus Oil Spot Primer 55 Gallon Drum

Seal Over Plus™ Oil Spot Primer Concentrated - 55 Gal Drum

SKU:

814.50

Qty:


Seal Over +™ is an oil spot primer concentrated version in a 55 gallon drum that you can dilute 1 to 1 so you don't pay more for shipping.  This is applied over an existing oil or grease spot in the pavement to prime for sealcoating.  Our formulat promotes adhesion and allows you to Seal Over the affected areas.  Break down the build up of oils and chemicals before sealing so it lasts like you want it to or because the specs said so.  Seal Over + is a concentrated formula and can be used without dilution over the worst areas but can be reduced by water to a 1 to 1 ratio for most oil spot treatments.

  • Concentrated Oil Spot Primer
  • Allows Seal Over the top of treated surface
  • Promotes adhesion of the asphalt seal
  • Clean Surface then apply by brush or spray

SURFACE PREPARATION:   Surface must be clean, dry and free of all dirt dust and debris.  Scrape or wire broom away excess buildup of oil, grease or petroleum residue prior to use.  Lightly burn off excess oil for improved bonding.

APPLICATION:   Mix well before use and before reduction.  Use full strength on heavy concentrated oil spots.  Reduce 1 to 1 or 1 to 2 with water depending on severity of oil buildup or staining.  Apply with a stiff bristled poly construction broom, brush or roller.  Scrub onto oil or grease spot and allow to dry.

COVERAGE PER GALLON:   300-400 ft.2 per dilute gallon.

 CAUTION:   KEEP FROM FREEZING. Wash tools in water.  Use suitable paint thinner if material has dried.  Do not store in direct sunlight.  Container should be closed when not in use.  Keep out of the reach of children.

PACKAGING:   5 gallon pails, 55 gallon drums and 275 gallon tote tanks.

IMPORTANT:   SPRINKLE A SLIGHT AMOUNT OF SILICA SAND ON SEAL OVER + TO IMPROVE ADHESION OF COAL TAR/ASPHALT EMULSION TYPE SEALER

 MATERIAL SPECIFICATIONS: REQUIREMENTS:
Weight per gallon, ASTM D1010, (lbs) 8.40 - 8.70
Viscosity @ 77°, ASTM D562 (Kreb’s Stormer Unit) 75-80 KU
% Nonvolatile by weight 30 - 40
Drying time (min) 20 - 40
Application Temp (°F) 50 min.
Film forming tester over oil Film must form over oily surface
Flammability Non-flammable
VOC Requirements 0.55 lbs/gal

 

Safety Data Sheet (SDS)Click to View PDF in New Window Click to Download PDF

Product Info Sheet (INFO)Click to View PDF in New Window Click to Download PDF

ProductWeight
Default Title506.0 lb

Add item(s) to your cart, then calculate shipping cost below: